This jumper does not need to stay on permanently.įor now remove the reset jumper and put it on the board like this. At a later stage you will need to reset the board in order to flash the chip. The picture below shows the reset jumper. I have attached the pin headers to the board on a soldering iron stand with crocodile clips.Īfter soldering it will look like this. To make the connection between the FTDI board and the Gotek drive we will solder some pin headers onto the Gotek board. This will allow you to re-flash the chip on the Gotek device. In order to be able to flash the STMicroelectronics chip you will need a FTDI FT232R serial to USB adapter board. Luckily it is not hard to change the firmware on the device to be able to boot ADF images from an USB drive. Gotek floppy disk emulator can not be used on an Amiga computer without modding it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |